Ruckus Wireless ZoneFlex 7343 Guía de usuario descargar pdf (Pagina 81)

Configuring the Access Point

Configuring Wireless Settings

NOTE: If you are using a ZoneFlex 7363/7962/7982 AP, go to Configuration > Radio

2.4G or Configuration > Radio 5G.

2. Click the Wireless # tab that you want to configure. The Configuration > Wireless

> Wireless[#] page appears.

3. Click the Encryption Method menu, and then click WEP. An additional set of WEP-

specific encryption options appear on this page.

4. Review the encryption settings listed in Table 24

, and then make changes as

required.

Table 24. WEP Options

5. Click Update Settings to save and apply the changes. A confirmation message

appears at the top of the page.

6. Click Go back to Wireless Configuration to reopen the previous page.

Using WPA

Wi-Fi Protected Access (WPA) and Wi-Fi Protected Access II (WPA2) are two security

protocols developed by the Wi-Fi Alliance in response to the weaknesses of WEP.

Encryption Setting Description

Authentication Mode Open is the only authentication mode

available with WEP encryption.

Encryption Strength • 64 bit: Specify the key with 10 hexadecimal

digits or 5 ASCII characters.

• 128 bit: Specify the key with 26

hexadecimal digits or 13 ASCII characters.

The 128-bit cryptography is stronger

privacy protection for your network and is

recommended if you use WEP.

Key Entry Method • Hexadecimal: The encryption key only

accepts hexadecimal characters (0-9, A-F).

• ASCII Text: The encryption key accepts

ASCII characters.

WEP Key Enter the key manually according to the Key

Entry Method and Encryption Strength

settings.

Key Index Choose the index, from “1” to “4”, that the

WEP key is to be stored in.

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 127 128

Sin comentarios

Ruckus Wireless ZoneFlex 7343 Guía de usuario Pagina 81